Tail Light Operational Functions: Turn Signal Light, Brake Light, Running Light, Emergency Flash and Back Up Light (Std.) (not including demonstration and standard flash modes)īack Up Lighting: On 69 Camaro Std. Number of Sequential Patterns: 11 > Industry First << We like to work with our customers to determine a ship date that works for everyone. However, if a customer has a more pressing need for a kit, we will do all we can to meet the timeline of the customer. You will receive a shipping notification with tracking information when it ships. Once we receive your order it will be put into our production schedule. The typical lead time for taillight kits is about 20 business days or less. Unlike a large corporation, we do not have the funds to keep completed kits in inventory. NOTE: We have developed multi-pattern sequential LED taillight kits for over 230 make, model and year vehicles. For LED lighting to function properly, a Low Current Flasher Module must be installed in place of the traditional turn signal flasher module. The kit is designed to work with OEM tail light housing and lenses as well as aftermarket components. There is no separate sequential lighting control module to mount and wire up. In addition, the kit includes a self-contained microprocessor and circuitry to enable a multitude of sequential lighting patterns. This includes low level running light illumination, brake light illumination, turn signal illumination, emergency flash and back-up lighting where applicable. The kits replace all the functionality of the light bulbs they replace. These kits incorporate high efficiency LED lights that increase tail light brightness, reliability and longevity. The BRAKE pattern is a 3 second sequence, the SHOW pattern is a continuous sequence.The Classic Sequential Tail Light (CST) kits are direct retrofit and replacement for incandescent light bulbs in classic vehicles. The show pattern will resume once the brake is released (if the SHOW was running). If the SHOW mode is on, and you hit the brake, the BRAKE pattern will always override the SHOW pattern for as long as the brake is held down. Connection must be a 12V POSITIVE source. SHOW = this pattern is activated when the yellow "SHOW" wire on the back of the light is connected to any 12V+ source, this can be done using our Show Mode Easy Install Kit (sold separately), a switch at your dash or a switch in your trunk (switch and wire sold separately). Unit ships pre-programmed with two patterns of your choice, BRAKE and SHOW.īRAKE = this pattern is activated upon hitting the brakes. This pattern will run for less than 3 seconds and then ALL the LEDs will come on solid until you let off the brake. We take the light apart, remove the existing LED circuit board, install our custom engineered programmable LED circuit board, seal the light back up, put the program of your choice in and ship it out, ready to go! All of our products are Plug-N-Play! At Seequenced, we modify OE and Aftermarket assemblies.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |